6.2 WAN Service
This screen allows for the configuration of WAN interfaces.
Click the Add button to create a new connection. For connections on ATM or ETH
WAN interfaces see Appendix G
.
ETH and ATM service connections cannot coexist. In Default Mode, up to 8 WAN
connections can be configured; while VLAN Mux and MSC Connection Modes support
up to 16 WAN connections.
Name of the interface for WAN
Name of the WAN connection
Shows the connection type
VLAN ID is used for VLAN Tagging (IEEE 802.1Q)
Shows Internet Group Management Protocol (IGMP) status
Shows Network Address Translation (NAT) status
Shows the Security status
Shows if IPv6 is enabled on this interface or not
Shows Multicast Listener Discovery (MLD) status
IPv6 Unnumbered
Model
Shows if the unnumbered model is used or not; Only ppp
interfaces can use this model and in this model, only IPv6
link-local address is used on the interface
Shows the connection status
Select interfaces to remove
To remove a connection, select its Remove column radio button and click Remove.
