103
(4) Select Configure S-ATA as parameter, then set to RAID
mode.
Note: The Configure S-ATA as parameter is disabled when the
ATA/IDE Mode is not set to Enhanced mode.
(5) Save settings and exit the BIOS setup utility.
The system reboots automatically.
2 During bootup, press Ctrl + E to run the RAID configuration utility.
Hold down the Ctrl key while you press E. The Management menu
appears.
Exiting RAID CU
Press Esc when in the utility’s Management menu to exit the utility.
AA G320_UG_EN.book Page 103 Tuesday, August 30, 2005 2:34 PM
