
Display Panel Instructions
Imprinter menu
Depending on the setting of the "Counter setting menu", the page number of the scanned document will
be printed. The imprinter option (KV-SS010) is required. If a host computer is connected, there may be
settings required on the host computer as well.
Item Contents
Setting the pre-imprinter
data
Allows for the selection of the printing content using an imprinter.
The imprinter will print on the printing (front) side of the document
scanned.
Setting the pre-imprinter
position
Allows for the selection of the printing position using a pre-imprinter.
Setting the post-imprinter
data
Allows for the selection of the printing content using an imprinter.
The imprinter will print on the reverse side of the document scanned.
Setting the post-imprinter
position
Allows for the selection of the printing position using a post-imprinter.
Another menu
Item Contents
Checking the version
Displays the firmware version of the mechanical control, pre-imprinter or
post-imprinter. If an optional imprinter is not installed, the imprinter
version will not be displayed.
Setting the buzzer
Selects whether the buzzer is turned on or off. If selection is in the "ON"
position:
When pressing a key, one short beep will be heard.
When there is an error, 5 short beeps will be heard.
When scanning is completed correctly, one long beep will be heard.
Setting the lamp Selects green or red color dropout.
Setting the SCSI ID Sets the SCSI ID number.
Setting the terminator
Sets "Enable" or "Disable".
Checking the roller cleaning
warning
The alarm tells you it is time to check the roller. If it is near 100%, clean
the roller. See "Cleaning the Unit" on page 30.
Clearing the roller cleaning
waning
Clear the "Clean Roller Warning 00%" display.
Checking the roller modules
replacement warning
The alarm tells you the roller needs to be changed. If it is near 100%,
replace the paper feed roller module and retard roller module.
See "Replacing Consurhable" on page 35.
Clearing the roller modules
replacement warning
Clear the "Replace Roll. Warning 00%" display.
Setting the product ID
Selects the product ID. The product ID setting depends on the host
computer scanner application you are using.
Setting the double feed
detector sensitivity
Selects the sensitivity of the Double Feed Detector.
13