121212
Page 12
Scribe EC Quick Installation Guide
with Prism PLUS Printer
Document Revision: 2004/12/07
ScribeEC with Prism PLUS printer
Installation Guide
Document Revision: 2004/12/28
Aligning the Prism PLUS Printer
(fig. 3)
(fig. 4)
(fig. 5)
Alert:
Before starting the Alignment Utility,
position the back end of the inkjet printe
in line with the dotted line on the top o
the drive bay.
1. From the Start Menu Open the SCRIBE E
Alignment Utility. It will be located in the folde
designated when you installed the alignmen
utility. Choose the appropriate COM Por
Number, which the Scribe EC Loader is
connected to, then choose the All other printers
or drive bay then Click the Start Test button (fig.
1).
2. Follow the onscreen instructions then Click Yes
button (fig. 2). The picker arm will then hover
disc over the open printer tray. Observe disc’s
position and make the appropriate adjustments to
the printer (fig. 3).
3. Click the Yes button when you are satisfied with
your adjustment (fig. 4).
4. The picker arm will then place a disc onto the
printer tray. Follow the on screen instructions
then click the OK button (fig. 5).
5. Once you are satisfied with the printer’s
alignment, tighten the thumbscrews located on
both side of the printer (fig. 6).
(fig. 1)
(fig. 6)
(fig. 2)
