8. Unpack the secondary hard drive.
9. Check the jumper setting on the back of the second drive.
Ensure that the jumper setting on the new device is set for "cable select" (see the documentation that came with the drive for information).
10. Install the primary hard drive:
a. Place the two bracket tabs into the drive slots inside the computer's front panel.
b. Swing the bracket forward so that it is flush with the the computer's front panel.
c. Replace the two bracket-securingscrews.
NOTICE: When you unpack the drive, do not set it on a hard surface, which may damage the drive. Instead, set the drive on a soft surface, such as a
foam pad, that will sufficiently cushion it.
