Produtos da Marca Dell

Back to Contents Page

 Memory

Dell™OptiPlex™FX160/160ServiceManual

Removing a Memory Module

Replacing a Memory Module

Your computer supports one or two memory modules.

Removing a Memory Module



1. Perform the procedure in Before Working on Your Computer.



2. Carefully spread apart the securing clips on each end of the memory module connector until the memory module pops out.



3. Remove the memory module from the connector.

Replacing a Memory Module



1. Place the module in the memory module connector, and align the notch in the module with the tab on the connector.



2. Press down on the module until the securing clips lock into place. If the clips do not click into place, remove the module and reinstall it.

NOTE: Your computer supports non-ECC, 667 MHz or 800 MHz, DDR2 SDRAM only. It supports memory module sizes of 512 MB (for embedded Linux

operating systems only), 1 GB, and 2 GB. When 800 MHz memory is installed, your computer operates at 667 MHz. See support.dell.com for more

information.

DIMM_1 memory connector

DIMM_2 memory

connector

securing clip (two per connector, white –

DIMM_1, black – DIMM_2)



NOTE: If your computer contains a single memory module, it must be inserted in the DIMM_1 memory connector. The DIMM_1 connector has white

securing clips.

NOTE: If the memory module is not installed properly, the computer may not boot. No error message indicates this failure.

DIMM_1 memory

tab in memory connector