Dil ID: 12
Dil Adı: portugal
Dil Kodu: pt6tayfun Produtos da Marca Dell
Dünyanın En Büyük
Elektronik Bilgi Kütüphanesi



Back to Contents Page
Drives
Dell™Inspiron™535/537/545/546ServiceManual
Removing a Hard Drive
Replacing a Hard Drive
Removing a Media Card Reader
Replacing a Media Card Reader
Removing an Optical Drive
Replacing an Optical Drive
Removing a Hard Drive
1. Follow the procedures in Before You Begin.
2. Remove the computer cover (see Removing the Computer Cover).
3. Disconnect the power cable and the data cable from the hard drive.
4. Remove the four screws securing the hard drive.
5. Slide the drive out towards the back of the computer.
6. If removing the hard drive changes the drive configuration, ensure that you reflect these changes in system setup (see System Setup).
7. Replace the computer cover (see Replacing the Computer Cover).
8. Connect the computer and other devices to an electrical outlet.
WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
WARNING: To guard against electrical shock, always unplug your computer from the electrical outlet before removing the cover.
WARNING: Do not operate your equipment with any cover(s) (including computer covers, bezels, filler brackets, front-panel inserts, etc.)
removed.
CAUTION: If you are replacing a hard drive that contains data that you want to keep, back up your files before you begin this procedure.
NOTE: If you are not replacing the hard drive at this time, disconnect the other end of the data cable from the system board and set it aside. You
can use the data cable to install a hard drive at a later time.
NOTE: The location and number of SATA connectors may vary based on your computer model. For more information, see System Board
Components.
1
screws (4)
2
power cable
3
data cable
4
SATA connector (on the system board)
CAUTION: Ensure that you do not scratch the screw holes with the screwdriver as the hard disk circuit board assembly is exposed here.