Produtos da Marca Dell



7. Connect the data cable to the drive and to the system board.



8. Check all connectors to ensure that they are properly cabled and firmly seated.



9. Replace the computer cover.



10. Connect your computer and devices to electrical outlets, and turn them on.

See the documentation that came with the drive for instructions on installing any software required for drive operation.

Floppy Drive



Removing a Floppy Drive



1. Follow the procedures in "Before You Begin."



2. Remove the drive panel.



3. Disconnect the power and data cables from the back of the floppy drive.



4. Grasp the sliding plate lever and push it towards the base of the computer; then, hold it in place while you slide the drive from the computer.

NOTICE: To connect a network cable, first plug the cable into the network wall jack and then plug the cable into the computer.

CAUTION: Before you begin any of the procedures in this section, follow the safety instructions located in the Product Information Guide.

CAUTION: To guard against electrical shock, always unplug your computer from the electrical outlet before removing the cover.

NOTE: If you are adding a floppy drive, see "Installing a Floppy Drive."

power cable

data cable