Proposal Number PSDF #P09-0004
A hinged-down panel constructed of the same material as the apparatus body and painted to match shall be
provided to cover the ladder rack hydraulic lift cylinder and pivot arm when the rack is in the stowed
position.
Front and rear facing flashing lights shall be installed on the rack and shall be illuminated when the rack is in
the lowered position. The outward side of the equipment rack that protrudes beyond the body of the
apparatus shall be stripped or painted with reflective material.
A red warning light shall be provided in the cab to warn the driver when ladder rack is not in the stowed
position. Cast aluminum ladder brackets with chrome plated quick release type mounting clamps shall be
provided to hold the ladders to the pivot arm assembly.
A locking device with a control on the side panel shall be provided that shall engage and hold the ladder rack
in the stored position. The locking device must be disengaged prior to the rack being lowered. The safety
lock must be included in the design of the ladder rack.
One (1) 14' Alco-Lite PRL-14 aluminum roof ladder with folding roof hooks shall be provided with the
apparatus.
One (1) 10' Alco-Lite FL-10 aluminum folding attic ladder shall be provided with the apparatus.
One (1) 24' two-section Alco-Lite PEL-24 aluminum extension ladder shall be provided with the apparatus.
One (1) 6' Akron IB-6-RK pike pole with I-beam fiberglass pole, standard steel hook and ram knob end shall
be provided with the apparatus.
One (1) 8' Akron IB-8-RK pike pole with I-beam fiberglass pole, standard steel hook and ram knob end shall
be provided with the apparatus.
One (1) 10' Akron IB-10-RK pike pole with I-beam fiberglass pole, standard steel hook and ram knob end
shall be provided with the apparatus.
BODY FENDERS - POLISHED
The apparatus body fenders shall be polished stainless steel and shall be rolled, die stamped and fully
removable. The stainless steel fenders and stainless fender liners shall be fastened with stainless bolts
and ESNA nuts to the outer fender panel.
REAR AXLE MUD FLAPS
Two (2) black, anti-sail, mud flaps shall be mounted behind the rear wheels.
BODY RUBRAIL
The apparatus body shall have a bolt on extruded, polished stainless steel rub rail affixed to the side beneath
each door area. The rub rail shall provide additional strength and protection and shall be constructed of 3/8"
x 1-1/2" stainless steel fastened with stainless steel fasteners. Each rub rail shall be attached to the apparatus
body with stand off spacers made from 1" diameter UHMW Polyethylene bar stock.
