Proposal Number PSDF #P09-0004
DEEP ALUMINUM SHELVES - ADJUSTABLE
Three (3) adjustable aluminum shelves shall be installed and shall have a flange 1-1/2" deep and a minimum
material thickness of .190" up to 30" in length. Each shelf shall be adjustable in height and held in place by
four (4) extruded uprights.
Location to be determined.
SHALLOW ALUMINUM SHELVES - ADJUSTABLE
Three (3) adjustable aluminum shelves shall be installed and shall have a flange 1-1/2" deep and a minimum
material thickness of .190" up to 30" in length. Each shelf shall be adjustable in height and held in place by
four (4) extruded uprights.
Location to be determined.
ALUMINUM TRAYS - PULL OUT
One (1) heavy duty pullout trays shall be installed and shall be equipped with Grant slides and a gas shock to
hold the tray in both the in and out positions and shall be made from .190" aluminum with a maximum
capacity of 250 pounds.
Location to be determined.
SWING-OUT VERTICAL TOOL BOARD
One (1) full height swing-out vertical tool board(s) with a150 pound capacity shall be furnished and installed
in an exterior body compartment.
The tool board shall be constructed of .25" aluminum.
A single D-Ring latch shall be provided that can easily be operated with gloved hands.
To be determined.
HYDRAULIC LADDER RACK STORAGE
An electric over hydraulic ladder rack shall be installed on the right side of the apparatus body to provide
ladder storage in a horizontal position above the side compartments. Power to the hydraulic cylinder shall be
supplied by means of a 12 volt electric motor power pack and shall be installed in an area that provides
proper protection of the electric and hydraulic components.
The ladder rack shall be of the single pivot arm design with no stabilizing arms at the front or rear to hinder
access to the side compartments with the rack in the lowered position. The ladder rack assembly shall be
located in the center of the body, above the rear wheel well area, with a weatherproof control switch
provided on the right side pump panel in full view of the rack. The ladder rack shall be designed so that it
will clear the compartment doors with the doors in the open position when the ladders are being raised or
lowered.
