• Installation
Connect the unit as follows:
• Operation
•
To place a call on hold
Press
*
**
*
and then HOLD. The caller will hear the audio source that
you have connected to the adapter.
•
To release the hold condition
Pick up any phone that is connected to that line, then press
*
**
*
, and the
adapter will release the call.
• Troubleshooting Guide
Open the lid by removing the 4 Phillips head screws; you will see the
circuit board (see below).
•
No Audio
Open both lids, pick up the phone and press
*
**
*
. One of the red LEDs
in the T-700-4, (see below) should light. Audio should be heard through the
ear piece of the telephone. If no audio is heard check the following:
!
Make sure the audio source is playing.
!
Make sure the volume on the audio source is turned up.
!
Make sure the audio cable is connected from the headphone
output of the audio source, to the audio jack on the T-700-4. Make
sure the type of jacks on the cable are the correct type. (male
phono or RCA for the T-700-4).
1 2 3
Message Source
Head
Phones
Wall Phone Jack - Lines 3 & 4
Phone Line
"Y" Adapter
Wall Phone Jack - Lines 1 & 2
Special 6 Wire
Splitter
Beige
Phone
Cord
3 or 4 Line Phone
7' Phone Cord
