Connecting Broadband Firewall Router to the Network
1. Connect one end of the UTP cable to the Broadband Firewall Router.
2. Connect the other end of the UTP cable to any network computer.
3. The connection is complete.
Connecting the AC Power Adapter
1. Connect the power adapter to the Broadband Firewall Router’s AC power adapter jack.
2. Plug the AC power adapter into a power outlet.
3. Turn the modem’s power on.
4. The connection is complete.
Note: DO NOT use any AC power adapter other than the one shipped with the Broadband
Firewall Router; using an incorrect AC power adapter may damage the Broadband
Firewall Router.
Power On Self Test (POST)
The Broadband Firewall Router automatically performs a Power On Self Test (POST) when
powered on. Successful powering up of the Broadband Firewall Router is indicated by one
flashes of the red LED marked Status on the topside of the Broadband Firewall Router. If the
Red LED does not flash one times, please contact your dealer for repair or replacement.
Resetting the Firewall Router
The Broadband Firewall Router has a reset button in the rear panel of the device. In some
circumstances you may need to reset the Broadband Firewall Router. Please follow the
instructions below to reset the Broadband Firewall Router.
1. With the Broadband Firewall Router powered on, press the reset button once. The red
LED light that is marked as Status will then flash once.
2. Reset the DSL/Cable modem.
5
