Notice:
The installer is responsible for the
dishwasher installation. Incorrect installation
is not covered by the warranty.
8. INSTALLER CHECKLIST
Your installer must have completed and
checked the following:
The dishwasher is square and level.
The dishwasher is fastened securely to
the cabinetry.
The dishwasher door opens and closes
freely. The dishwasher door must close
without hitting any cabinetry or counter
top.
The inlet water supply is turned on and
checked for leaks.
The drain hose has been connected and
checked for leaks. There must be no
kinks or obstructions in the drain hose.
The drain hose must be installed with a
28” (710mm) high drain loop for drain
hook-ups without any air removed.
If the dishwasher drain is hooked up to a
garbage disposal, the drain hopper plug
must be removed.
The spray arms are free and rotate freely.
The rinse cycle has been run.
The water level will be below the filter
screen after the end of the wash program.
It is normal to find some water in the drain
filter area.
Set the water softener to the correct water
hardness for your area. If the dishwasher
drain is connected to a garbage disposal,
make sure that the drain/hopper plug has
been removed.
9. FINAL INSTRUCTIONS
1. Press the On/Off button to turn the
dishwasher on.
2. Power indicator light comes on.
3. Use the Cycle Select button to choose a
washing program.
4. Start the program with the Start/Pause
button.
5. Run the dishwasher through one
complete cycle. When the progress
indicator light “End” lights up, the wash
cycle is completed. Use the On/Off button
to turn the dishwasher off.
Notice:
If the dishwasher does not operate properly,
refer to the self-help hints.
10. SELF-HELP HINTS:
The power indicator light doesn’t come on:
Check to make sure the circuit breaker to
the dishwasher is in the On position.
Check all the wire connections in the
junction box are tight and not loose.
No water is coming into the dishwasher:
Check to make sure the hot water shut-off
is in the On position.
Water does not drain:
Make sure drain hose is not kinked or
comes out of air gap next to the sink.
Remove drain hose from disposal, making
sure plug is removed.
Notice:
If your dishwasher is not operating
properly after following these steps:
Contact your dealer to schedule an
authorized service agent to inspect your
new dishwasher for any function-related
failure.
The manufacturer warranty does not
cover installation or customer education
service visits.
You will find the model a
nd serial number
information on the label located on the right-
hand side of the inner door of your
dishwasher, as shown above.
Notice:
Please make a copy of your invoice and
keep it with this manual. You will need it
when you call for service (1-800-932-4267).
18
