SCION xA/xB Light Enhancement 2006 - INTERIOR LIGHT UPGRADE
Section II – Installation Procedure
Page 2 of 11 pages
PPO
Rev: A 05/10/05
A. Check Kit Contents
1. Check kit for content and damage.
B. Vehicle Preparation
1. Remove battery negative terminal
2. Apply protective covering to vehicle interior.
C. Remove Center/Lower Dash
xA Only (C1-C4)
1. Remove the silver side trim. (Fig. C1)
i. Pull the silver side trim straight back.
2. Remove storage box fascia by pulling straight
back. (Fig. C2)
3. Remove the lower cover.
i. Using a clip removal tool, remove the (2)
push fasteners.
ii. Remove the lower cover by pulling straight
back. (Fig. C3)
4. Remove the ashtray/lighter panel.
i. Remove the ashtray. (Fig. C4)
ii. Remove the (2) screws and pull the panel
straight back. (Fig. C5 & C6)
iii. Disconnect the lighter connector from the
back of the panel. (Fig. C7)
xB Only (C5-C11)
5. Remove the (2) outer ventilation knobs.
(Fig. C8)
6. Remove the (2) screws. (Fig. C9)
7. Pull straight back on the panel. (Fig. C10)
8. Disconnect the (3) connectors from the back of
the panel. (Fig. C11)
STOP
STOP
Fig. C3 Fig. C4
Fi
. C5
Fig. C6
STOP
STOP
Fig. C7
Fig. C1
Fi
. C2
Fig. C8
Fig. C9
Fig. C10
Fig. C11
