SCION TC 2006 - AMP / SPEAKER UPGRADE
Preparation
Page 10 of 11 pages
Remove Rear Speaker by removing (3) 10mm bolts.
Disconnect Speaker wiring plug. (FIGURE 23)
Replace speaker using the same bolts removed
above. Reconnect Speaker wiring plug.
Re-assemble all removed parts in reverse order
as removed.
Re-install Drivers seat and torque to 30 ft.lbs.
DRIVERS SIDE INS T ALLATION IS THE
SAME AS PASSENGERS SI DE
Clean up and remove any trash.
Reconnect the NEGATIVE battery cable as shown
in FIGURE 25. The cable must be connected at 45
degrees, and torque to 36 lbf-in.
Proceed to Functional Verification s (page 11)
FIGURE 23
FIGURE 25
CAPACITOR INSTALLATION (FIGURE 24)
Using a nylon tool pop out the mirror switch plate.
Connect the black lead to the brown/yellow wire pin 7
Connect the red lead to the blue wire pin 8
Attach one T-tap to the blue wire at pin 8
Attach one T-tap to the brown/yellow wire at pin 7
TO MIRROR SWITCH CONNECTOR
FIGURE 24
Re-install mirror switch plate.
