
Appendix - Parameter List
Print Server User Manual 232
Table 39: Parameter List - Logical Printer
Parameters Value Description
lp*_prt_port
[Printer port]
depends on the print
server model
Defines the port used by the logical printer
for printing.
This parameter is only available for print
server models with several physical printer
ports.
lp*_tcp_port
[TCP/IP port]
max. 4 characters; [0-9]
0-9999
Defines the TCP/IP port of the relevant
logical printer.
lp*_mode
[Banner page
mode]
ASCII Defines the format in which the banner
page will be printed.
lp*_job_start
[Job start]
max. 256 characters Defines a start sequence.
Depending on the application, you might
have to configure the logical printer. These
sequences may consist of PRESCRIBE or
ESC commands. ESC commands consist
of job start sequence '\027' followed by the
actual control characters preceded by a
backslash and written as a decimal. Job
end sequence '\027 \012', for example,
triggers a form feed after the print job. For
more information, please look up the
available ESC commands in your printer
manual.
lp*_job_end
[Job end
sequence]
max. 256 characters Defines an end sequence.
(see above)
lp*_search
[Search]
max. 256 characters
no wildcard or
truncations
Defines a string which is searched for in
the data sent to the print server.
Using 'Find' and 'Replace,' you can look for
strings in the data sent to the print server
and replace them with new strings.
lp*replace
[Replace]
max. 256 characters
no wildcard or
truncations
Defines the string which is replaced in the
data sent to the print server. (see above)
lp*_crlf
[CR + LF]
on/off Enables/disables the conversion from line
feed (LF) to carriage return with line feed
(LF+CR).
lp*_banner
[Banner page]
on/off Enables/disables the printing of a banner
page or when the LPD protocol is used.