Installation Guide 7010 Peeler Unit
This guide is provided for use by service representatives who must install the
peeler unit. If the peeler is not installed, please contact your supplier.
(1) Check to make sure that the printer's power switch is turned off then disconnect the
power cord.
(2) Open the top cover and lift the thermal printhead and sensor arm.
(3) Remove the operation panel on
the front of the printer (2 screws).
When doing this, remove the
flexible cable that is connected
to the operation panel.
(4) Remove the front right cover on
the front of the printer. (2 screws)
Head open lever
Sensor arm open lever
Thermal printhead
Flexible cable
Sensor arm
Top cover
Operation
panel
Front right
cover
Note Installation requires a cross-point ('Phillips') screwdriver with magnetic tip and a
shaft at least 200 mm (8 inches) long.
Caution
