20
Wash program guidance
o The washer dryer automatically selects a spin speed for a particular
wash program. However it is possible to reduce the spin speed by
using the spin reduction feature.
o Important: You should make sure that the selected spin speed is
appropriate for the garments that you are washing.
o If you use the spin reduction feature, you can make the machine
not go into a spin cycle. If you pick this option, then the machine
will stop with water in the drum.
o Important: Before opening the door of the appliance, you MUST
select the drain program to clear this water.
o The LED display indicates an approximate time remaining for the
selected wash cycle. Please note that factors external to the
machine, e.g. the temperature of your water supply, your water
pressure etc. can affect the time it takes for the wash cycle to
complete.
Selecting a wash program
o Load your laundry into the machine and put detergent in the
relevant compartment of the soap drawer. Please refer to the
program table on pages 16-17 for maximum load weights.
o Close the porthole door firmly.
o Select the most appropriate wash program for the garments that
you are washing, by turning the program selection knob (B).
o Select any program options by using the stain remover button
(H), extra rinse button (I), cold wash button (L) or anti-crease
button (M).
o Any program option that you select, will affect the length of time
that the wash cycle will take to complete.
o Alter the spin speed if required, using the spin speed selection
button (F).
o Press the Start / Pause button (N).
o After approximately 5 seconds, you will hear your washer dryer
start the wash cycle.
