TABLE OF CONTENTS
ILLUSTRATIONS ..................................................................................................................... i
INTRODUCTION ...................................................................................................................... ii
IRR-30P RECEIVER ................................................................................................................ 1
Receiver front panel .................................................................................................................. 1
Receiver rear panel .................................................................................................................. 1
Mounting the receiver ................................................................................................................ 1
Overall System Setup ................................................................................................................ 1
IRH-15c MIC/TRANSMITTER ................................................................................................. 2
Batteries and Power Mode for the IRH-15c ................................................................................ 2
Frequency selection .................................................................................................................. 2
Using the
IRH-15c
..................................................................................................................... 2
IRN-10 MIC/TRANSMITTER ................................................................................................ 2-3
Batteries for the IRN-10 ............................................................................................................. 2
Frequency selection .................................................................................................................. 2
Using the IRN-10 ...................................................................................................................... 3
External Mic Jack ...................................................................................................................... 3
INTERNAL CHARGING ........................................................................................................... 3
IRD-60 SENSOR ..................................................................................................................... 4
TROUBLESHOOTING ............................................................................................................. 5
SPECIFICATIONS .................................................................................................... back cover
TROUBLESHOOTING
The single most important thing to ALWAYS check when trouble arises are the
batteries. Make sure they are fresh and the POWER LED is glowing brightly.
SYMPTOM CAUSE
No POWER LED a. Receiver switch is set to OFF - change to ON
b. External 15VDC power source is not connected or is
malfunctioning
c. Dead or very weak battery in transmitter
No audio from IRN-10 a. Make sure the volume on the receiver is turned up for the
appropriate channel and the IRN-10 is powered ON
b. If
two
transmitters are being used, make sure they are set
to different frequency channels
c. Make sure the batteries are fresh or fully charged and
installed correctly
No audio from IRH-15c a. Make sure the volume on the receiver is turned up for the
appropriate channel and the IRH-15c is powered ON
b. If
two
transmitters are being used, make sure they are set
to different frequency channels
c. Make sure the batteries are fresh or fully charged and
installed correctly
Intermittent audio a. Make sure there is a clear path between the transmitter
and the receiving sensor. Best results are obtained when
the receiving sensors are mounted high - above
everyone’s head
Limited working range a. Install extra external sensors
b. If using IRH-15c set the Power Mode to Hi
