If the temperature and the level of
the water is too high, the door
lock symbol stays on. You cannot
open the door. If necessary, do
the following procedure to open
the door:
1.
Deactivate the appliance.
2.
Wait for some minutes.
3.
Make sure that no water is in
the drum.
If you deactivate the appliance, it
is necessary to set the programme
again.
AT THE END OF PROGRAMME
1.
The appliance stops automatically.
2.
The acoustic signals operate, if it is
active.
3.
In the display goes on and the
message tells you that the pro-
gramme is completed.
4.
The indicator of button
6
goes off.
5.
The door lock symbol goes off.
6.
Press button
1
to deactivate the ap-
pliance. After five minutes from the
end of the programme, the AUTO
OFF function automatically deacti-
vates the appliance.
When you activate the appliance
again, the display shows the end
of the last set programme. Turn
the programme knob to set a new
cycle.
7.
Remove the laundry from the appli-
ance. Make sure that the drum is
empty.
8.
Keep the door ajar, to prevent mil-
dew and odours.
9.
Close the water tap.
The washing programme is completed,
but there is water in the drum:
– The drum turns regularly to prevent the
creases in the laundry.
– The door stays locked.
– You must drain the water to open the
door.
To drain the water:
1.
If necessary, decrease the spin speed.
2.
Touch button
6
. The appliance
drains the water and spins.
3.
When the programme is completed
and the door lock symbol goes off,
you can open the door
4.
Press button
1
to deactivate the ap-
pliance.
The appliance drain and spin au-
tomatically after approximately 18
hours.
22
www.aeg.com
