Dil ID: 7
Dil Adı: french
Dil Kodu: fr2tayfun Produits de la Marque Whirlpool
Dünyanın En Büyük
Elektronik Bilgi Kütüphanesi



31
Detergent and additive product residues in
dispenser at end of wash.
Check whether:
the siphon is correctly installed and clean
(see “Care and Maintenance”);
enough water is being supplied. The mesh filters
between the inlet hose and the tap could be
blocked (see “Care and Maintenance”). Check
and clean the filter two or three times a year
(see “Removing the filter”).
The appliance vibrates during the spin cycle.
Check whether:
the appliance is levelled and solidly installed on
all four feet (see “Installation Instructions”);
the transit bolts have been removed. The transit
bolts must be removed before the appliance can
be used (see “Installation Instructions”).
Final spin results are poor:
The appliance has an imbalance detection and
correction system. If individual heavy articles are
loaded (bathmat, bathrobe, etc.) this system may
reduce the spin speed automatically to protect the
appliance or even interrupt the spin cycle
altogether, if the imbalance is too great even after
several spin starts.
If the laundry is still too wet at the end of the
cycle, add smaller articles of laundry to balance
the load and repeat the spin cycle.
Excessive foam formation may prevent spinning.
Ensure correct amount of detergent is used
No water or insufficient water supply:
the appliance has a safety hose and the safety
valve has opened (red indicator in the safety
valve inspector window).
In this case replace it with a new safety hose.
What should I do when the automatic safety system detects a malfunction?
The programme is interrupted and various indicators (if available) point to the source of the fault.
Fault description table
Small lamp lights up Digital display Fault description
“Water tap” “FH” “Water inlet fault”
- “FP” “Draining fault”
- from “F4” to “F15” “Electrical components fault”
“Water Stop” “FA” “Water Stop fault”
3gb05030.fm5 Page 31 Monday, September 17, 2001 3:33 PM