
GB
-5-
Rectifying minor faults yourself...
Switching off the appliance. Everything OK...
Wash cycle
Select program
10
9
6
7
8
Exercise caution when opening the door: beware of hot steam.
Only press the OFF button once the START indicator lamp has switched off.
All the indicator lamps switch off. Unload the appliance, starting from the lower rack in order to avoid any residual drips of water falling onto crockery below.
Maintenance and care
Filters
Check and
clean if
necessary
Unscrew filter
cylinder, remove it
and fine sieve...
Rinse under running
water...
Screw on filter cylinder NOTE MARK!
Unscrew
and remove
upper arm...
Spray arms
Remove
blockages/
deposits
Insert
Clean spray
nozzles under
running water
(use toothpicks if
necessary)...
Insert and screw on lower and upper arms tightly.
Maintenance and care
Change the program in progress:
• Press the START button (for 2 seconds) until the START indicator lamp
switches off.
• (Water drains for up to 60 seconds).
•Select a new program.
• Press the START button.
Unscrew
and remove
lower arm...
Overview of programs
The max. possible number of programs is illustrated in the chapter “Chart”. The corresponding programs for your appliance can be found on the panel (page 1).
Choose program according to the attached table of programs (page 1).
Duration of the program depends on the external conditions in the apartment, temperature and pressure etc.
The dishwasher door must be closed and the water tap open.
To load crockery, open the door with caution:
Close the door again.
The program resumes the cycle from where it was interrupted.
Beware of hot steam!
The wash cycle can be interrupted at any time by pressing START (see chapter “What to do if...”).