GB
-1-
Chart
PROGRAMS
SELECTION
BUTTON
Push “Programs” button
(repeatedly) until the indicator
of the required program lights
up (see “Table of programs” -
next page).
BEFORE USING THE APPLIANCE FOR THE FIRST TIME CAREFULLY READ THIS QUICK REFERENCE GUIDE AND THE ASSEMBLY INSTRUCTIONS!
MULTIZONE
Allows you to choose the
washing zones. Press this
button (repeatedly) to
select the wash zones:
both racks
only lower rack
only upper rack
(including
cutlery rack)
- indicator lits
DELAYED START
BUTTON
Push the button
(repeatedly) to delay the
start of the program.
Adjustable from 1 to 24
hours. With each press of
the button, the delayed
start indicator increases
by one hour and after 24
restarts from 0. Then
press the START button.
The dishwasher will start
after the set time.
RINSE AID INDICATOR
When lit (at the end of the
cycle), the rinse aid dispenser
needs to be refilled.
ADPS 5540
5019 396 01883
POWER CLEAN
Thanks to the additional
power jets this option
provides a more intensive
and powerful wash in the
lower rack, in the specific
area. This option is
recommended for washing
pots and casseroles (see
page 7). Press this button to
activate Power Clean (the
indicator lights up).
TABLET SETTING
This setting allows to
optimize the cycle
performances according the
type of detergent used.
Push the Tablet button for 3
seconds (until the indicator
lights up) if you are using the
combined detergents in
tablet (rinse aid, salt and
deteregent in 1 dose). If you
are using powder detergent
or liquid detergent, the
Tablet indicator on the
control panel has to be off.
SALT INDICATOR
When lit (at the end of the
cycle), the salt reservoir needs
to be refilled.
WASH TIME DISPLAY
Indicated the cycle duration and the remaining time (h:min). With “Delayed start” selected
it indicates the time remaining until program start (h.00) - below 1h (0:mim).
If “Fx Ey” messages appears on the display, see page 9 - chapter “What to do if...”.
THE CONTROL PANEL OF THIS DISHWASHER ACTIVATES PUSHING ANY BUTTON EXCEPT CANCEL/OFF BUTTON.
FOR ENERGY SAVING THE CONTROL PANEL DEACTIVATES AUTOMATICALLY AFTER 30 SECONDS IF NO CYCLE HAS STARTED.
START/RESUME
BUTTON
Push this button to start the
selected program: the
indicator lights up and goes
off at the end of the
program.
When the door is opened
during a washing cycle, the
cycle is temporarily
paused: the Start indicator
blinks.
To resume the cycle close
the door and push Start
button again.
CANCEL/OFF
BUTTON
Push this button to switch off
the control panel.
If pressed when a program
is running it cancels the
program ongoing draining
water for 1 minute (0:01 is
shown into the display).
If pressed when the
dishwasher is switched
off, it drains any possible
liquids from dishwasher
(1minute process).
Quick reference guide
