WARNING!
If ov er flow occu rs , t ur n of f th e m ain wa t er s upp l y befo re ca l lin g a se r vi ce .
If there is water in the base pan because of an overfill or small leak,
thewatershouldberemovedbeforerestartingthedishwasher.
Longer inlet time.
Fau cets is not opened , or water inta ke is restricted, or water
pressure is too low.
Malfunction of temperature sensor or of heating element.
Short circuit or break of temperature sensor
Open circuit or break of temperature sensor
Longer heating time,
but not reaching required temperature
Failure of temperature sensor
Failure of temperature sensor
Som e element of dishwasher leaks .
Overflow.
The dishes were not
loaded correctly .
See notes in " Loading the Dishwasher Baskets ".
Select a more intensive programme.
See" Wash Cycle Table ."
Use more detergent, or change your detergent.
Rearrange the items so that the sp ay can rotate freely.r
Clean and/or fit the filter combination co rrectly.
Clean the sp ay arm jets. See "Clea ning the Spray
Arms".
r
Use less detergent if you have soft water and select
a shortest cycle to wash the glassware and to get
them clean.
Use a mild abrasive cleaner to eliminate those marks.
Re-loading the dishes properly.
Load the dishwasher as suggested in the directions.
Increase the amount of rinse-aid/refill the rinse-aid
dispenser.
Do not empty your dishwasher immediately after
washing. Open the door slightly s o that the steam can
escape. Begin unloadi ng the dishwasher only once t
he dishes are barely warm to the touc h. Empty the low
basket first. This prevents water form dropping off
dishes in the upper basket.
In short program the washing temperature is lower.
This also lowers cleaning performance. Choose
a program with a long washing time.
Water drainage is more d ifficult with these items.
Cutlery or dishes of this type are not suitable for
washing in the dishwasher.
The programme was
not powerful enough.
Not enough detergen t
was dispensed.
Items are blocking
the path of spray arms.
The filter combination
inthebaseofwash
cabinet is not clean or
is not correct ly fitt ed.
This may cause
the sp ay arm jets
to get blocked.
r
Combination of soft
water and too much
detergent.
Aluminum utensils
have rubbed against
dishes.
Dishes block
detergent cups.
Improper loading
Too little rinse -aid
Dishes are removed
too soon
Wrong program
has bee n selected
Use of cutlery with
a low-quality coating
Error Codes
Uns a ti s
-factory
was hin g
res u lt
Uns a ti s
-factory
dry i ng
res u lt
