10 At the confirmation message , press Œ).
The computer will reboot, and the operation of reinstalla
tion for the hard disk starts automatically.
CWinaSwsiiSl
After the “restore” procedure completes, a message will
be displayed. Remove the Product Recovery CD-ROM,
then close the tray.
(T)Turn the computer off and remove the CD drive.
@Set the floppy disk drive in the multimedia pocket and
put the FIRSTAID FD into the floppy disk drive, then
turn the computer on.
Follow the on-screen instructions.
4Wir^Q^2'OjOO)M4Win30^
When the message “insert the next CD” is displayed, in
sert the Product Recovery CD-ROM showing the next
number in the sequenee, and then select [OK].
(In the case of Windows NT, only Product Recovery CD-
ROMs 1 and 2 can be used.)
{note)--------------------------------------------------s
If [OK] is not immediately selected:
The message “The media does not contain the correct
file” may appear. When [OK] is selected, the message
“insert the next CD” will be displayed again.
Confirm that the proper Product Recovery CD-ROM
has been inserted by opening the tray of the CD drive
and then close the tray, then immediately select [OK].
11 After the reinstallation procedure completes, the follow
ing message will appear on the display. Remove the floppy
disk or Product Recovery CD-ROM, then restart the com
puter by pressing ( Ctrl ) -I- [ Alt ) -i- C Pel ).
4Winclow^98l
All data on the whole HDD has been restored to the factory default.
After removing floppy disk, restart the computer and set up Windows
again.
4WirK)owsf2W0>
Windows 2000 install wizard will start after reboot.
Restore process will execute more after Windows 2000 install wizard.
Restart the computer after removing Product Recovery CD-ROM,
4Wii^ow^NJ#
Windows NT4.0 install wizard will start after reboot.
Restore process will execute more after Windows NT4.0 install
wizard.
Restart the computer after removing Product Recovery CD-ROM.
12 When the message [Press <F2> to enter SETUP] is dis
played, press ( F2 ) and then run the Setup Utility.
If the password has been set, enter the Supervisor Pass
word.
13 Press
At the confirmation message, select [Yes] and press
C Enter ]. (The Setup Utility settings will return to their
default values. Even the security settings with the excep
tion of the password(s) will return to their default values.)
A^note>
If there are added functions that are not listed in the
Specifications of this Operating Instructions, we rec
ommend disabling their device settings. If the settings
are enabled, additional operations may be necessary
during the Windows setup procedure. (We also rec
ommend referring to the Supplementary Instructions,
if they are included with the computer.)
14 Using eitheror
0
, select [Exit] and then select
[Save Current Values], then press (Enter).
At the confirmation message, select [Yes] and press
t Enter).
15 Powder off your computer.
16 Perform the setup procedure for Windows by following
the instructions on the screen.
(Refer to the Supplementary Instructions, if they are in
cluded with the computer.)
Page 11
C3"Page 12
77 Run the Setup Utility and change the settings where nec
essary.
4Windowsl98l
4Wincl0^2W0mWinaQwsII^T*
A note>
When the message [Operating System not found] is
displayed, press rbtrD + fAit) + fPiD
and perform the operations from Step 12 to Step 14.
If you fail to press ( F2 ) in Step 12 , restart the com
puter and perform the operations from Step 12 to Step
14 after finishing Windows setup procedure.
25
