EC-1040GB Workstation
Page 51
Step 4: Disconnect all internal and external peripheral device connections from the
PCI/ISA expansion card.
Step 5: Remove the CPU card clamp. (See Section 4.5.2)
Step 6: Remove the retention screw that secures the PCI/ISA expansion card to the slot
on the rear panel.
Step 7: Slide the PCI/ISA expansion card out of the workstation.
Step 8: Install a new PCI/ISA expansion card. (See Section 4.5.9)
Step 9: Reinstall the CPU card clamp.
Step 10: Reinstall the top cover of the workstation. (See Section 4.5.9)
Step 11: Reinstall the workstation into the rack. Refer to Section 4.6 for complete
mounting instructions.Step 0:
5.4 Backplane Replacement
To replace a backplane, please follow the instructions below.
Step 1: Turn off and disconnect the workstation from all power sources.
Step 2: Remove the workstation from the rack in which it is installed.
Step 3: Open the top cover of the EC-1040GB rackmount workstation.
(See Section 4.5.1)
Step 4: Remove the CPU card clamp. (See Section 4.5.2)
Step 5: Disconnect and remove all CPU cards (see Section 4.5.9) and PCI/ISA
expansion cards (see Section 4.5.10).
Step 6: Remove the retention screws that secure the backplane to the workstation
(see Section 4.5.8).
Step 7: Install a new backplane into the chassis.
