5
Installing and removing an interface card
CAUTION:
• Before you install or remove an interface card, wear an ESD wrist
strap and make sure the strap makes good skin contact and is
reliably grounded.
• To avoid device dama
e, do not use excessive force when you install
or remove an interface card.
Installing an interface card
Before you install an interface card, remove the filler panel (if any) from
the target slot. Keep the removed filler panel secure for future use.
To install an interface card:
1. Unpack the interface card.
Figure 2 LSWM124XGT2Q interface card
(1) Ejector lever (2) Latch
2. Press the latch on the interface card to release the ejector lever.
3. As shown by callout 1 in Figure 3, i
nsert the interface card slowly
into the slot along the guide rails.
4. Rotate inward the ejector lever as shown by callout 2 in Figure 3
until the
latch locks the ejector lever in place.
