Clearing NVRAM
To clear NVRAM for all devices and restart the computer:
1. Enter the system setup program.
2. Press the right-arrow key to move to the Advanced menu.
3. Select the Boot Configuration submenu by pressing <Enter>.
4. Press the down-arrow key to highlight Reset Config Data. Then change the setting to Yes (see "Boot Configuration Submenu").
5. Press <F10> to exit the program and restart the computer.
Clearing Forgotten Passwords
If you forget your supervisor or setup password, you cannot operate your computer or change settings in the system setup program until you clear the
forgotten password(s).
1. Shut down the computer.
2. Turn off any attached devices and disconnect them from their electrical outlets.
3. Disconnect the power cable from your computer, and then press the power button to ground the system board.
4. Open the computer cover.
5. Locate the configuration jumper on the system board, and move the jumper plug so that pins 2 and 3 are jumpered (to "clear" the password when you
turn on the computer).
6. Close the computer cover, connect your computer to an electrical outlet, and turn on the computer.
NOTICE: The following procedure resets all standard settings for your computer. Before proceeding, record all current settings so that you can restore
them when you finish this procedure.