Installation instructions
Any electrical and/or plumbing work required to install this appliance
should be carried out by a qualified electrician and/or plumber or
competent person.
Remove all packaging before positioning the machine.
If possible, position the machine next to a water tap and a drain.
Fitting under a counter
(kitchen worktop or sink)
By removing the machine’s worktop, you
can install it under a close fitting sink unit
or a pre-existing top, providing the
dimensions of the recess correspond to
those shown in the picture.
Proceed as follows:
Remove the machine’s worktop by
unscrewing the two rear retaining
screws, pull the worktop from the back
of the machine and slide out the front
slots, lifting the worktop.
Insert the machine after adjusting the levelling with the adjustable feet.
When inserting the machine, ensure that the water inlet and drain hoses are
not kinked or squashed.
During all operations that involve accessibility to internal components the
dishwasher has to be unplugged.
Be sure that once the appliance has been installed, it is easily accessible for
the service engineer in the event that a repair is required.
If the dishwasher is later used as a free-standing appliance, the original
worktop must be re-mounted.
The plinth on free-standing appliances is not adjustable.
37
Installation instruction
156997 66/0en 23-10-2006 12:04 Pagina 37
