Something not working
The dishwasher will not start or stops during operation. Certain problems are due
to the lack of simple maintenance or oversights, which can be solved with the help
of the indications described in the chart, without calling out an engineer.
Switch off the dishwasher and carry out the following suggested corrective actions.
Fault code and malfunction Possible cause and solution
• continuous flashing of the light of the run-
ning programme,
• 1 intermittent audible signal
•
1 flash of the end of programme indicator
light,
The dishwasher does not fill with water.
• The water tap is blocked or furred with lime-
scale.
Clean the water tap.
• The water tap is turned off. Turn the water
tap on.
•The filter (where present) in the threaded
hose fitting at the water inlet valve is
blocked.
Clean the filter in the threaded hose.
• The water inlet hose has not been correctly
laid or it is bent or squashed.
Check the water drain hose connection.
• continuous flashing of the light of the run-
ning programme,
• 2 intermittent audible signals
•
2 flashes of the end of programme indica-
tor light,
The dishwasher will not drain.
• The sink spigot is blocked.
Clean out the sink spigot.
• The water drain hose has not been correctly
laid or it is bent or squashed.
Check the water drain hose connection.
• continuous flashing of the light of the run-
ning programme,
• 3 intermittent audible signals
•
3 flashes of the end of programme indica-
tor light,
Anti-flood device is activated.
• Close the water tap and contact your local
Service Force Centre.
28
Something not working
