Activation/deactivation of the 3 IN 1 function
Press the 3 IN 1 button: the corresponding indicator light illuminates. This means
that the function is active.
To deactivate the function press the 3 IN 1 button again: the indicator light turns
off.
If the drying results are not satisfactory we suggest that you:
1. Fill up the rinse aid dispenser with rinse aid.
2. Activate the rinse aid dispenser.
3. Set the rinse aid dosage to position 2.
• The activation/deactivation of the rinse aid dispenser can only be possible with
the "3 IN 1 function" active.
Activation/deactivation of the rinse aid dispenser
1. Press the On/Off button. The dishwasher must be in setting mode.
2.
Press simultaneously buttons B and C, until the lights of buttons A , B, and C
start flashing.
3.
Press button B, the lights of buttons A and C turn off while the light of button
B goes on flashing: the end of programme indicator light illuminates, indicating
that the rinse aid dispenser has been activated.
4.
To change the setting, press button B again until the end of programme indi-
cator light turns off.
5. To memorise the operation, switch off the dishwasher by pressing the On/Off
button.
If you decide to turn back to the use of standard detergent system we advise that
you:
1. Deactivate the "3 IN 1 function".
2. Fill up the salt container and the rinse aid dispenser again.
3. Adjust the water hardness setting to the highest setting and perform 1 normal
washing programme without loading any dishes.
4. Adjust the water hardness setting according to the hardness of the water in
your area.
5. Adjust the rinse aid dosage.
22
Use of detergent
