Dil ID: 10
Dil Adı: spain
Dil Kodu: es1tayfun Productos de la Marca Zanussi Electrolux
Dünyanın En Büyük
Elektronik Bilgi Kütüphanesi



37
Connecting the dishwasher
Connecting to the water
supply
The dishwasher can be connected to cold or hot
water supplies up to max. 60°C.
The dishwasher must not be connected to open
hot water appliances or instantaneous water heat-
ers.
Permitted water pressure
Connecting the inlet hose
1 The water inlet hose must not be kinked,
crushed or entangled when it is being con-
nected.
Connect the threaded hose fitting (ISO 228-1:2000)
on the water inlet hose to a tap with an external
thread (¾ inch). The inlet hose is fitted with either a
plastic or a metal nut:
Only tighten the nut hand tight.
Then do a visual check for water tightness. (Make
sure that the tap is not dripping.)
3 So that access to the tap in the kitchen is not
restricted by the use of the dishwasher, we
recommend installing an additional tap, or fit-
ting a T-branch to the existing tap.
If you need a longer water inlet hose than that sup-
plied, the following VDE-approved complete hose
sets are to be used. These are available from your lo-
cal Service Force.
Water drainage
Drain hose
1 The drain hose must not be kinked, crushed or
entangled.
Connecting the drain hose:
Maximum permitted height: 1 metre.
Minimum required height: 40 cm above the bot-
tom edge of the appliance.
Lowest permitted water pressure:
1 bar (=10 N/cm2 =100 kPa)
Consult your plumber if the water pressure is less than
1 bar.
Highest permitted water pressure:
10 bar (=100 N/cm2 =1 MPa)
If the water pressure is greater than 10 bar, a pressure
reduction valve must be used (available from your
dealer).