EN -1-
Chart
(see at right for options description)
PROGRAM SELECTION
BUTTON
Push “P” button (repeatedly)
until selected program number
is shown on the display
(P1...Px) - see “Table of
programs” below.
START/RESUME BUTTON
Push this button to start the selected program: the
indicator lights up and goes off at the end of the
program.
When the door is opened during a washing cycle,
the cycle is temporarily paused: the Start indicator
blinks. To resume the cycle close the door and
push Start button again.
CANCEL/OFF BUTTON
Push this button to switch off the control panel.
If pressed when a program is running it cancels the
program ongoing draining water for 1 minute
(0:01 is shown into the display).
If pressed when the dishwasher is switched off,
it drains any possible liquids from dishwasher
(1 minute process).
1) Program data obtained in conformity with European standard EN 50242, obtained under normal conditions (without additional options) and may vary depending on
conditions. Differences of up to 20 minutes are possible with sensor programs as a result of the appliance’s automatic calibration system.
2) Reference program for energy label in compliance with EN 50242 regulations. - Note for Testing Institutes: for detailed information on the EN/Standard
loading comparison test and other tests, contact the following address: “
[email protected]”.
3) The antibacterial action has been tested by the Institut Pasteur of Lille (France), based on the NF EN 13697 standard of November 2001.
RECYCLING WATER SYSTEM: these programs save water in a dedicated tank.
A TANK CLEANING CYCLE (at least 45 min.) is automatically run every 30 cycles or after every power off, to assure the best product conditions.
* Power consumption in: Left-on mode: 0.70 W / Off-mode: 0.40 W.
Table of programs
Deter-
gent
Consumption
Drying
Phase
Programs
Available
options
Loading instructions
Litres kWh
Minutes
1)
P1
Sensor 40°-70°C
Delay
Half Load
Recommended program for routine washes,
with dried-on food (e.g. EN 50242)
X 7-15 1.00-1.70 70-172 Full
P2
Pre-Wash cold
Delay Crockery to be washed later.
— 4.0 0.01 14-16 NO
P3
Fragile 40°C
Delay Light soiling, for example glasses and cups.
X 10.5 0.85 105-114 Light
P4
Rapid 45°C
Delay
Lightly soiled crockery, with no dried-on
food.
X 11.0 0.85 30-50 NO
P5
Eco
2)
50°C
Delay
Half Load
Normally soiled crockery.
Standard Program the most efficient in terms
of its combined energy and water
consumption.
X 6.0 1.03 185 Full
P6
Fast Daily 60°C
Delay
Half Load
Normally soiled crockery.
X 11.0 1.30 80-95 Full
P7
Silent 50°C
Delay
Normally soiled crockery, gentle and quiet
thanks to the lower spray pressure (39 dBa).
X 10.0 1.20 290-299 Light
P8
Intensive 65°C
Delay
Recommended program for heavily soiled
crockery, especially suitable for pans and
saucepans.
X 11.0 1.60 165-175 Full
P9
Steam
Delay
Program including steam action dedicated
for heavily soiled crockery, pots and pans.
Soaking or hand pretreatment is no longer
needed.
X 11.0 1.75 180-190 Full
P10
Hygiene
3)
Delay
Normally or heavily soiled crockery, with
additional antibacterial wash. Program
interruption (e.g. due to door opening) can
compromise elimination of germs.
X 14.0 1.40 110-120 Full
5019 300 00741
BEFORE USING THE APPLIANCE FOR THE FIRST TIME CAREFULLY READ
THIS QUICK REFERENCE GUIDE AND THE ASSEMBLY INSTRUCTIONS!
Options and display description
SALT INDICATOR
When lit (at the end of the cycle),
the salt reservoir needs to be
refilled.
RINSE AID INDICATOR
When lit (at the end of the cycle),
the rinse aid dispenser needs to
be refilled.
WASH TIME DISPLAY
Indicated the cycle duration and the remaining time (h:min). With “Delayed start” selected it indicates
the time remaining until program start (h.00) - below 1h (0:min).
If “Fx Ey” messages appears on the display, see page 6 - chapter “What to do if...”.
THE CONTROL PANEL OF THIS DISHWASHER ACTIVATES PUSHING
ANY BUTTON EXCEPT CANCEL/OFF BUTTON.
FOR ENERGY SAVING THE CONTROL PANEL DEACTIVATES
AUTOMATICALLY AFTER 30 SECONDS IF NO CYCLE HAS STARTED.
TABLET SETTING
This setting allows to optimize
the cycle performances
according the type of
detergent used. Push the
Tablet button for 3 seconds
(until the indicator lights up)
if you are using the combined
detergents in tablet (rinse aid,
salt and detergent in 1 dose).
If you are using powder
detergent or liquid detergent,
the Tablet indicator on the
control panel has to be off.
DELAYED START
BUTTON
Push the button (repeatedly)
to delay the start of the
program. Adjustable from
1 to 24 hours. With each
press of the button, the
delayed start indicator
increases by one hour and
after 24 restarts from 0.
Then press the START
button. The dishwasher will
start after the set time.
HALF LOAD BUTTON
Half load cycle can be used
for the upper or lower rack.
Select the required program
then press the “Half Load”
button - the light comes on.
Turns off at the end of the
program.
The “Half Load” option can
be used with the programs
indicated in the table of
programs.
Quick reference guide
