30
:: Radio Tray Assembly (cont.) - Bag K
:: Fuel Tank Install - Bag L
25203
3x12mm
fhcs
89066
O-Rings
89128
Fuel tank
mount
21173
Small
body clip
89131
Fuel tank
76mm
cut
:: Brake bias adjusters
:: Rear :: Front
:: 9
:: 6
:: 5
1mm
gap
:: 2
:: 3
:: 1
:: 4
x2
x2
x2
x2
::1 - Turn on transmitter and buggy. Adjust servo
horn until position is parallel with centerline at
neutral.
::2 - Set pre-load on spring so that throttle will
close.
::3 - Set 0.5mm gap on throttle collar.
::4 - Trim off excess rod.
::5 - Pull cams to engage brakes. Set collar
(with brakes engaged) to have 1mm gap
between tubing and collar.
Remember: transmitter is still on during this
step.
::6 - Trim off excess brake link wire.
::7 - Set throttle EPA to max. Apply full throttle on
transmitter and set EPA so that the carb is full
open. Be careful not to over-extend the carb.
::8 - Set max brake EPA at 30% as a starting point.
::9 - Brake bias adjusters: thread the adjuster into the
mount to achieve stronger brakes on that end of
the buggy.
