English - 27
BASIC OPERATIONS
Before you start
1. Open the water tap.
Check if the water supply hoses are correctly connected to
the corresponding tap (cold/hot water).
2. Plug the power cable into a 220 V wall socket.
3. Ensure that the drain hose is placed as instructed.
1
2
3
Washing for the first time
1. Place the laundry into the tub, add an appropriate amount of detergent, and then close the
door. For eective washing, add detergent and bleach into the tub before adding the laundry.
2. Press the POWER button.
3. Press the Baby care or Course button to select a cycle.
4. Press the Water Level button to specify the water level according to the load of laundry and
select the water supply type (cold or hot water).
High Mid Low
1.5 - 3 kg 0.8 - 1.5 kg 0.8 kg or less
The default water level is set for each cycle, and the default water supply type is cold water.
5. Press the Rinse button to select the number of rinse cycle.
(The number of rinse cycles cannot be changed during the last rinse cycle or the spin cycle.)
6. Press the START/PAUSE button.
7. Close the door.
• If the door stays open when the washing machine starts operating, the washing machine
will stop the current operation for safety reasons. (However, the water supply will
continue even though the door is opened)
• To change the wash cycle, press the START/PAUSE button, select a cycle and then
press the START/PAUSE button again.
• If you want to add the soak cycle, press the Soak button before starting the wash. The
Soak cycle is not available for courses: Super Clean, Delicates, Rinse + Spin, Spin, or
Eco Tub Clean.
Untitled-1 27 2014-11-26 4:21:20
