Buzzer
A buzzer sounds at the end of the
programme or if there is a fault.
You will hear the buzzer at the end of a
programme. It will sound four times in
bursts of three beeps with a noticeable
pause (approx. 15 seconds) in
between.
In the event of a fault, the buzzer will
sound four times in bursts of three
beeps with only a very short pause in
between.
The buzzer is activated as standard at
the factory.
You can deactivate the buzzer at the
end of a programme if you wish. The
buzzer which sounds when there is
fault cannot be deactivated.
^ Open the door.
^ Switch the dishwasher off using the
On/Off button K.
^ Press the Programme selector button
in, and whilst holding it in switch
the dishwasher on using the On/Off
button K.
Keep the programme selector button
pressed in until the lower right hand
programme indicator comes on.
If this does not happen, start the
procedure from the beginning again.
^
Press the Turbo button 4 times.
The Turbo indicator will flash briefly 4
times at intervals.
The flashing sequence in the Time
display shows what the current setting
is.
–
"p1": the buzzer is activated
–
"p0": the buzzer is deactivated
^
If you want to change the setting,
press the Programme selector
button.
The setting is now stored in memory.
^ Switch the dishwasher off using the
On/Off button K.
Additional functions
38
