23
If the shaver is subjected to a major change
in temperature, pressure or humidity, let
it acclimatise for 30 minutes before you use it.
Compliance with standards
This shaver complies with the internationally
approved safety regulations and can be safely used
in the bath or shower and cleaned under the tap.
This Philips appliance complies with all standards
regarding electromagnetic elds (EMF). If handled
properly and according to the instructions in this
user manual, the appliances are safe to use based
on scientic evidence available today.
General
The appliance is equipped with an automatic
voltage selector and is suitable for mains voltages
ranging from 100 to 240 volts.
The adapter transforms 100-240 volts to a safe
low voltage of less than 24 volts.
Charging
Note: The shaver cannot be used directly from the
mains.
AT911/AT891/AT890 : It takes approx. 1 hour to
fully charge the shaver.
AT751: It takes approx. 8 hours to fully charge the
shaver.
When you charge the shaver for the rst time or
after a long period of disuse, let it charge until the
charging light lights up continuously.
A fully charged shaver provides up to 16 (AT911/AT891/
AT890) or 13 (AT751) cordless shaves. The shaving
time may be less than 16 (AT911/AT891/AT890) or
13 (AT751) cordless shaves as a result of your shaving
behaviour, your cleaning habits or your beard type.
-
-
-
-
-
ENGLISH
Charge indications
Battery low
When the battery is almost empty (when there
are only 5 or fewer shaving minutes left), the
charging light starts to ash orange.
When you switch off the shaver, the charging light
continues to ash orange for a few seconds.
Quick charging (AT911/AT891/AT890)
When you start charging the empty battery,
the charging light alternately ashes orange and
green. After approx. 3 minutes the charging light
continues to ash green. The shaver now contains
enough energy for a 5-minute shave.
Charging
When the shaver is charging, the charging light
ashes green.
Battery fully charged
When the battery is fully charged, the charging
light lights up green continuously.
Note: After approx. 30 minutes, the charging light goes
out to save energy.
Charging
1 Put the small plug in the shaver.
2 Put the adapter in the wall socket.
The charging light shows the charging status of
the shaver (see section ‘Charge indications’ in
this chapter).
-
-
-
-
-
,
ENGLISH