Configuring Your Wireless Connection
The DG950 ships with wireless LAN security set by default. See the security label
on your product (shown on image at the left) for the factory security settings: net-
work name (SSID), encryption method, network key, and WPS PIN.
Note: You must set up your computer and other client devices to work
with the security settings on the DG950. Refer to the documen-
tation for your client device for instructions on setting security.
If your computer or client device supports WiFi Alliance WPS
(Wireless Protected Setup), activate WPS on your computer or
client device and the DG950 simultaneously to easily set up your
system security.
If you need to modify the Data Gateway’s default wireless security settings, or if you
want to configure any other wireless LAN settings, refer to the following instruc-
tions.
Accessing the Configuration Interface
Follow these steps to access the configuration interface. You should have already set
up the DG950 as described in Installing and Connecting Your Data Gateway
.
1 a) If security has been properly set up on your computer to access the wire-
less LAN on the DG950, use the connection utility for your operating system
to connect to the wireless LAN using its network name (SSID), as shown on
the security label.
b) If you cannot access the wireless LAN, you must first establish a wired
Ethernet connection between your computer and the DG950.
2 In your web browser, open the page http://192.168.0.1/ to access the
wireless router setup.
The Login screen displays.
Note: The default user name is “admin”. The default password is “pass-
word”, in lower case letters.
3 Enter the user name and password and click the Apply button to log in.
The System Basic Setup screen displays.
Touchstone DG950 Data Gateway User’s Guide
Safety
Getting
Started Installation
Ethernet
Configuration Usage Troubleshooting Glossary
22
Security Label
