Interrupting a programme
Press the button 5 to interrupt a programme
which is running, the corresponding green pilot
light starts blinking.
Press the button again to restart the pro-
gramme.
Cancelling a programme
Turn the selector dial to
to cancel a pro-
gramme which is running. Now you can select a
new programme.
Opening the door
After the programme has started the door is
locked. If, for any reason, you need to open it,
set firstly the machine to PAUSE by pressing
the button 5. After a few minutes it will be pos-
sible to open the door.
If the door remains locked, this means that the
machine is already heating or that the water lev-
el is too high. In any case, do not try to force the
door!
If you cannot open the door but you need to
open it you have to switch the machine off by
turning the selector dial to
. After a few mi-
nutes the door can be opened (pay attention
to the water level and temperature!).
After closing the door, it is necessary to select
the programme and options again and to press
button 5.
At the end of the programme
The machine stops automatically. The light of
button 5 and the light corresponding to the just
finished washing phase go off.
The light C illuminates. After a few minutes the
door can be opened.
If you have set a programme or an option that
ends with water left in the tub, the light C illumi-
nates. The door remains locked to indicate that
the water must be emptied out before opening
the door. During this time, the drum continues
to run at regular intervals until the water drain-
ing.
Follow the below instructions to empty out the
water:
1.
Turn the programme selector dial to
.
2. Set the draining or spinning programme.
3. If needed, reduce the spin speed, .
4. Press button 5.
At the end of the programme, the door can be
now opened. Turn the programme selector dial
to
to switch the machine off.
Remove the laundry from the drum and carefully
check that the drum is empty. If you do not in-
tend to carry out another wash, close the water
tap. Leave the door open to prevent the forma-
tion of mildew and unpleasant smells.
Stand by: once the programme has finish-
ed after a few minutes the energy saving
system is enabled with the pilot lights switched
on. By pressing any button the appliance will
come out of the energy saving status.
Care and cleaning
Warning! You must DISCONNECT the
appliance from the electricity supply,
before you can carry out any cleaning or
maintenance work.
Descaling
The water we use normally contains lime. It is a
good idea to periodically use a water softening
powder in the machine. Do this separately from
any laundry washing, and according to the soft-
ening powder manufacturer's instructions. This
will help to prevent the formation of lime depos-
its.
External cleaning
Clean the exterior cabinet of the appliance with
soap and water only, and then dry thoroughly.
Cleaning the dispenser drawer
The washing powder and additive dispenser
drawer should be cleaned regularly.
13
www.zanussi.com
