•To restart the programme from the point at which it was interrupted,
press the button 9.
• After the programme has started the door is locked. If, for any reason,
you need to open the door, set firstly the appliance to PAUSE by
pressing the button 9. After a few minutes it will be possible to open
the door.
If the door remains locked, this means that the appliance is already
heating or that the water level is too high. In any case, do not try to
force the door!
If you cannot open the door but you need to open it you have to switch
the appliance off by turning the selector dial to
. After a few
minutes the door can be opened (pay attention to the water level
and temperature!). After closing the door, it is necessary to select the
programme and options again and to press the button 9.
10
Door light The pilot light 10 illuminates when the programme starts and indicates if
the door can be opened:
• light on: the door cannot be opened. The appliance is working or has
stopped with water left in the tub.
• light off: the door can be opened. The programme is finished or the
water has been emptied out.
• light blinking: the door is opening in a few minutes.
At the end of the programme
The appliance stops automatically. The pilot light of the
button 9 and the pilot light 10 go off. The display shows
.
If a programme or an option that ends with water left in
the tub has been selected, the pilot light 10 remains on
and the door is locked to indicate that the water must
be emptied out before opening the door.
Follow the below instructions to empty out the water:
•
Turn the programme selector dial to
.
• Select the draining or spinning programme.
• Reduce the spin speed if needed, by pressing the
relevant button.
• Press the button 9.
At the end of the programme, the door can be now
opened. Turn the programme selector dial to
to
switch the appliance off. Remove the laundry from the
drum and carefully check that the drum is empty. If you
do not intend to carry out another wash, close the water
tap. Leave the door open to prevent the formation of
mildew and unpleasant smells.
Warning! If there are children or pets in the
house, activate the child safety device in the in-
ner side of the door frame (for more details read " Child
safety" in the chapter "Safety Information").
Stand by : during programme setting up and once the
programme has finished, if the programme selector dial
and any button are not touched, after a few minutes the
energy saving system is enabled. The pilot lights and
the display go off. The green pilot light of the button 9
flashes with a low frequency. By pressing any button
the appliance will come out of the energy saving status.
Door seal
At the end of every cycle,
check from the door seal
and remove objects that
could be trapped in the
fold.
18
