$0.
Disconnect the power connector from the
stator terminals.
1
'l
.
Disconnect the wire standoff and edge
connector from the
half sensor cover.
NOTE:
If
present, slide or cut the wise
tie
from around the edge connector.
Wire
Sta
ndoff
REASSEMBLY
MOTE:
When you reinstall
the drive motor rotor over the stator assembly.
do
not
grip
the rotor housing around
the
rear
edge with your fingers.
The magnets around
the rotor housing are very strong, and they
will
pull
the rotor into the stator
coil
magnets
when
the rotor magnets come within their
magnetic
fieid.
Keep your fingers along the
outside
of
the rotor housing and away from
the rear edge when you are installing it on the
stator assembly.
f
'I.
.'
2
Pry
up
on the
two
locking tabs and pull
the hall sensor cover
off
the stator hous-
ing.
NOTE:
In the top right photo, there
are
two
indents on the housing to mark
where the
hall sensor cover
is
installed.
Be sure to snap the
two
tabs on the half
sensor cover into these indents when you
reinstal!
it
on the stator assembly.
Drive
Motor Stator
Assernbiy
Half
Sensor Cover
Drive
Motor Rotor
Assernbfy
