25
EN
FINISH IN Moves the end of your programme
to a later time. Helps to prot from
more favourable energy rates (for
example during the night), or to have
the laundry ready at a certain time.
Only if you add detergent manually:
use powder - and not liquid -
detergent with this function to ll the
detergent compartment for manual
dosing.
Choose a delay up to 23:30 hours.
• Select programme, temperature
and options.
• Press the “Finish in” button –
the button light goes on, and
the display indicates that the
“Finish in” delay can be entered.
• Press the UP or DOWN key to
select the desired period until
end of the programme.
• When you have nished your
settings, press “Start / Pause”
– the light over the button
lights up solidly. The display
indicates that the cycle has started,
and afterwards the countdown
of the remaining delay. The door
locks.
• The programme starts
automatically to complete at
the end of the delay period.
After programme start, the
display indicates the remaining
programme duration and the
current programme phase.
To cancel the delay
• either press “Start/Pause” to cancel
the delay; to start the selected
programme immediately, press
“Start/Pause” again
• or press and hold “On/O” to
cancel the complete programme
setting.
Due to factors like load balancing,
foam reduction or other
unforeseeable inuences on
programme duration, it may occur
that the programme nishes earlier
or later than dened with the “Finish
in” function. In this case, the display
indicates, after programme end, that
the programme has nished earlier
or later.
SETTINGS
The following settings can be
changed:
Language (= display language) /
key tones / cycle end alert / display
contrast / water hardness / eco mode
(automatic switch-o function after
programme end) / dispenser on or
o (permanently enable or disable
automatic detergent dosing) /
calibration (adapt dosing amount of
the Tanks to the recommendations of
your detergent or softener) / Tank2
content (= set Tank2 to detergent or
softener) / factory settings (= return
to factory settings).
• Press and hold the Settings button
for at least 3seconds.
• Press the UP or DOWN key to select
the setting which you want to
change; it is marked by an arrow.
Conrm it by pressing the OK key.
• Press UP or DOWN key to adjust the
setting; conrm by pressing the OK
key.
• To exit the Settings mode, either
press the Settings button, or wait
a few seconds until the settings
mode is exited automatically.
