5019 496 01157
Before using the dishwasher, read the installation and maintenance instructions carefully!
1
GB
GSIK 5010
1) Programme data obtained in conformity with European standard EN 50242. The data may vary, for example, according to different loads, extra
functions, different settings, water supply temperatures, water hardness and power supply voltage.
2) Programme for energy data label in conformity with EN 50242. - Information for Test Laboratories:
for detailed information on the EN/Standard
loading comparison test and other
tests, contact the following address: “[email protected]”.3) The antibacterial action has been proven in collaboration with the Pasteur Institute of Lille (France), in conformity with. Standard NF EN 13697 of
November 2001.
1. OVERVIEW
Programme selection button
Press the button (repeatedly) until the indicator lamp of the
desired programme lights up (see table 1.1).
At the end of the wash cycle, the last programme selected is
memorized.
Half Load/Multizone
Half load cycle can be used for the upper or lower rack. Select
the programme then press the “Half load” button. The indicator
lights up, and goes off at the end of the programme. This
function can be used with the programmes indicated in table 1.1
At the end of the programme, the most recently selected setting
remains memorised.
Detergent setting upon initial use and when using a different
type of detergent
Indicator lamp off = Powder/gel detergent (factory setting).
If using combined detergents, press and hold the button for 3
seconds; the indicator lamp lights up = rinse aid and salt
indicators are deactivated.
From water hardness level 5, the salt indicator remains active.
At the end of the programme, the most recently selected setting
remains memorised.
Delayed Start button
Press the button repeatedly to delay the start of the
programme by 2, 4 or 8 hours. Then press the Start/Resume
button. The remaining time is indicated by the corresponding
indicator lamp. The wash programme will start after the set
time. The set delay will be memorised at the end of the cycle,
and can be selected by pressing the button again.
Start/Resume button
The indicator lamp lights up during operation, flashes when the
programme is interrupted before completion and switches off
at the end of the programme.
Cancel/Off button
Press the button to switch the dishwasher off or to interrupt
the selected programme.
If the Cancel/Off indicator lamp flashes repeatedly, this indicates
a fault: see chapter 5 “What to do if...”.
Salt level indicator and rinse aid level indicator
These light up at the end of the programme if salt or rinse aid
needs topping up. Only add just before starting a wash cycle.
Table 1.1.
Programme Table
Detergent
dispenser
Consumption
1)
P
Programmes
Additional
options
Description of programme
large small Litres kWh Minutes
1
Pre-Rinse cold
Crockery to be washed later. — — 4.0 0.03 14 ±
1)
2
Quickwash 45°C
Lightly soiled crockery, with no dried-
on food.
X — 11.0 0.80 30 ±
1)
3
Bio Normal
2)
50°C
Normally soiled crockery. Energy-
saving programme.
X X 12.0 1.05 165 ±
1)
4
Hygiene +
3)
Normally or heavily soiled crockery,
with additional antibacterial wash.
Stopping a programme underway (e.g.
by opening the door) can compromise
the elimination of bacteria.
X X 13.0 1.50 115 ±
1)
5
Intensive 70°C
Recommended programme for
heavily soiled crockery, especially
suitable for pots and pans.
X X 14.0 1.55 155 ±
1)
