
Function 3: Extension programming IP E-Class Administrator’s Manual
C.2
10. AutoPage — Lets the user turn AutoPage (defined below) on or off at his/her station.
Note: This feature is used in conjunction with the directory names recorded in Function 62 and is not ac-
tive until a directory name is recorded for the extension.
If the station user has his/her mailbox set to answer with personal greeting 3 and a caller presses 3
to page that user, this feature automatically pages the station user in the page zones entered in
Function 31. If no page zone is entered, all ESI Feature Phones on the system are paged.
Default: Disabled.
Note: When AutoPage is enabled, the IP E-Class system will use the last installed idle digital port to per-
form the page. Therefore, if a phone is on the last installed port, the phone’s user may experience
a brief delay in telephone operation if he/she picks up the handset (or presses SPEAKER) during
the AutoPage.
11. External forwarding — Allows the station user to use the call forwarding/off-premises and off-
premises “reach-me” features. See the User’s Guide for more information about these features.
Default: Enabled.
Note: After the system dials the external forwarding number, it will play a prompt saying, “You are receiv-
ing a forwarded call. Press any key to accept.” This prompt will play continuously for 30 seconds. If
the forwarded call is answered and the called person dials a digit, the forwarded call will be con-
nected to that person. If no digit is dialed, the caller is automatically forwarded to voice mail. While
the two lines (trunks) are connected, the system constantly monitors the line for open loop condi-
tions (hang-up). If an open loop is detected on either line, the call is disconnected. The system also
monitors for voice activity on the connected lines; if voice is no longer detected, the call is discon-
nected. Finally, if both lines are connected for more than 60 minutes
1
, the call will be disconnected.
12. Forwarding to toll numbers — This feature is used in conjunction with external forwarding (see
previous item). When enabled, this feature lets the user program a long-distance number for exter-
nal forwarding.
Default: Disabled.
(Continued)
1
Default timer setting. To adjust this, contact ESI Technical Support.