Problem Possible cause and solution
There are stains and dry wa‐
ter drops on glasses and
dishes.
• The released quantity of rinse aid is not sufficient.
Adjust the rinse aid level to a higher level.
• The quality of the rinse aid can be the cause.
The dishes are wet. • For the best drying performance activate the option
XtraDry and set AirDry .
• The programme does not have a drying phase or
has a drying phase with low temperature.
• The rinse aid dispenser is empty.
• The quality of the rinse aid can be the cause.
• The quality of the multi-tablets can be the cause.
Try a different brand or activate the rinse aid dis‐
penser and use the rinse aid and multi-tablets to‐
gether.
The interior of the appliance
is wet.
• This is not a defect of the appliance. Humid air con‐
densates on the appliance walls.
Unusual foam during wash‐
ing.
• Use the detergent designed specifically for dish‐
washers.
• There is a leak in the rinse aid dispenser. Contact
an Authorised Service Centre.
Traces of rust on cutlery. • There is too much salt in the water used for wash‐
ing. Refer to "The water softener".
• Silver and stainless steel cutlery were placed to‐
gether. Avoid to put silver and stainless steel items
close together.
There are residues of deter‐
gent in the dispenser at the
end of the programme.
• The detergent tablet was stuck in the dispenser
and therefore was not completely washed away by
water.
• Water cannot wash away the detergent from the
dispenser. Make sure that the spray arms are not
blocked or clogged.
• Make sure that items in the baskets do not impede
the lid of the detergent dispenser from opening.
Odours inside the appliance. • Refer to "Internal cleaning".
• Start the programme with a descaler or a clean‐
ing product designed for dishwashers.
ENGLISH 23
