product for dishwashers. Follow
carefully the instructions on the
packaging of the product.
12. TROUBLESHOOTING
If the appliance does not start or it stops
during operation. Before you contact an
Authorised Service Centre, check if you
can solve the problem by yourself with the
help of the information in the table.
WARNING!
Repairs not properly done
may result in serious risk to
the safety of the user. Any
repairs must be performed by
qualified personnel.
With some problems, the display
shows a message.
The majority of problems that can
occur can be solved without the need
to contact an Authorised Service
Centre.
Problem Possible solution
You cannot activate the appli-
ance.
• Make sure that the mains plug is connected to the
mains socket.
• Make sure that there is no damaged fuse in the
fuse box.
The programme does not start. • Make sure that the appliance door is closed.
• Press OK
• If the delay start is set, cancel the setting or wait
for the end of the countdown.
• The appliance has started the procedure to re-
charge the resin inside the water softener. The du-
ration of the procedure is approximately 5 mi-
nutes.
The appliance does not fill with
water.
The display shows the mes-
sage: Appliance is not filling wa-
ter.
• Make sure that the water tap is open.
• Make sure that the pressure of the water supply is
not too low. For this information, contact your lo-
cal water authority.
• Make sure that the water tap is not clogged.
• Make sure that the filter in the inlet hose is not
clogged.
• Make sure that the inlet hose has no kinks or
bends.
The appliance does not drain
the water.
The display shows the mes-
sage: Appliance is not draining
water.
• Make sure that the sink spigot is not clogged.
• Make sure that the filter in the outlet hose is not
clogged.
• Make sure that the interior filter system is not clog-
ged.
• Make sure that the drain hose has no kinks or
bends.
ENGLISH
21
