• While on-hook, press TRSF and then dial 100.
• Dial your four digit station passcode.
• Dial 1 for locking outgoing, 2 for locked all calls or 0 to unlock.
• Press TRSF to store your selection.
NOTE: When your keyset is locked for outgoing, the HOLD key will flash. When
your keyset is locked for all calls, the HOLD key will light steady.
MANUAL SIGNALLING
Use this feature when you want to send a brief 500ms ring burst to another sta-
tion, regardless of the status of your phone (on-hook, off-hook, handsfree, DND or
ringing).
To send a signal to another station:
• Press the Manual Signalling (MS) key.
• You may press the MS key repeatedly to send multiple signals to the designat-
ed station.
NOTE: Your phone must have a Manual Signalling (MS) key with a station number
extender assigned to it.
OFF-HOOK VOICE ANNOUNCE
Keysets may receive a voice announcement while on another call.The calling sta-
tion must have an OHVA key.When you are in DND, you cannot receive OHVA calls.
The OHVA feature will work with intercom calls and transferred calls.
To make an off-hook voice announcement:
• Dial the extension number or press the DSS key.
• When you receive a busy signal, press the OHVA key.
• After the attention tone, begin speaking.
• Finish the call by replacing the handset or pressing the ANS/RLS or the MON-
ITOR key if you are using a 7B phone.
NOTES:
1. When you are voice announcing to a station close to you, use the handset to
avoid an echo effect.
2. You cannot off-hook voice announce to single line telephones.
37
500_DCS_Screen.qxp 12/2/2005 9:43 AM Page 43
When you receive an off-hook voice announcement, if you are using the handset,
you will hear the announcement over the handset receiver. If you are using the
speakerphone, you will hear the announcement over the keyset speaker. In both
cases, you can continue to speak to the original party.
• Press the flashing CALL button on your keyset.This will place the original party
on hold and allow you to talk to the announcing party.
• To return to your first party, press the key corresponding to your original call.
This will disconnect the OHVA call.
Executive off-hook voice announce allows you to engage in conversation on your
keyset and simultaneously receive and reply handsfree to an OHVA through your
add-on module (AOM). Use caution because the conversation through the AOM
may possibly be heard by the caller on the keyset.When you receive an executive
OHVA through your AOM:
• Reply by speaking in the direction of the microphone in the AOM unit.
• Adjust the volume with the VOL keys on the AOM unit.
• Press the SPK or the MONITOR key on the AOM to disconnect the announcing
party.
NOTES:
1. Executive off-hook voice announce can only be accomplished when an AOM is
attached to your phone.
2. If the MUTE key on the AOM is lit, you must press the AOM’s SPK key to answer
the OHVA call.
OHVA BLOCK
Your keyset can be programmed with an OHVA Block (BLOCK) key. Pressing this
key will prevent anyone from making an OHVA to you until you press the button
again and cancel the blocking.
OHVA REJECT
Your keyset can be programmed with an OHVA Reject (REJECT) key. Pressing this
key while receiving an OHVA call will disconnect the voice announcing party and
return you to your original call.
38
500_DCS_Screen.qxp 12/2/2005 9:43 AM Page 44
