Configuring STP/RSTP
13-29
STP Configuration Commands
The following table lists the commands for configuring STP on the Corecess R1-SW24L2B:
Table 13-16 STP configuration commands
Command Description
port pathcost Sets the spanning-tree port path cost for the specified Ethernet port.
port priority Sets the spanning-tree port priority for the specified Ethernet port.
port stp
Enables or disables STP(Spanning Tree Protocol) on the specified
Ethernet port.
show stp port Displays spanning-tree information for the specified port.
show stp vlan Displays spanning-tree information for the specified VLAN interface.
stp adminEdge port Configures a port as an Edge port.
stp bridge-priority Sets the bridge ID for a VLAN.
stp forward-delay Sets the bridge forward delay for a VLAN.
stp hello-time Sets the bridge hello time for a VLAN.
stp max-age Sets the bridge maximum aging time for a VLAN.
stp pathcost-encoding Configures the type of Spanning Tree Protocol encoding mode.
stp protocol-version
Configure the type of Spanning Tree Protocol mode to run for a specific
VLAN.
stp vlan Enables the spanning tree algorithm for a specific VLAN.
